Get the full benefit from your new Carbs and high flow mufflers by bypassing the H box. These pipe Sets (2) are custom designed for the CX/GL500, for an application where the pipes will be mounted in the stock location, horizontal to the ground. Pipes come marked to take the guesswork out of determining the side and front mount.
Easy installation, just weld (tig or mig) to the joint ring at the front. The pipes are 1 3/4″OD so any muffler slides over and clamps onto them.
The pipes can be trimmed at the front or the rear, You can trim up to 2 inches at the front and up to 6 at the back to allow for lining up the mounting brackets to fit your application.
These custom pipes sweep around the foot peg mounts and allow for free movement of the stock shifter and brake pedal. They are available in 2 styles as shown in the photo.
These work for any of the CX or GL V-twins.
| Weight | 4 lbs |
|---|---|
| Dimensions | 21 × 6 × 5 in |
| Angle | Upswept, Stock |
18 reviews for Honda CX500 and CX650 Midpipe Set (2)- H Box Bypass, upswept or stock
Only logged in customers who have purchased this product may leave a review.
Related products
All Carb Kits
All Gaskets
All Gaskets
Jason H. (verified owner) –
They fit right in the exsisting original exaust ends making it easier to weld a bead and seal the pipes.
Bernard V. (verified owner) –
These pipes were excellent . I did not weld them on . I had the pipe enlarged at the end so I could slip them on to the front pipe & used a muffler clamp to hold it on. The mufflers I used just slipped right on & also clamped good & solid. Really all great .
Jens Erdmann (verified owner) –
Perfect
Kyle (verified owner) –
Perfect upsweep angle
Todd M. (verified owner) –
Can’t wait to get around to this project in the wintertime
BENJAMIN (verified owner) –
Exactly as described. Fit well.
Chase Williams (verified owner) –
Fit great and will completely change the look of my bike!
Chance (verified owner) –
They fit great, clear everything and look good!
Shawn P. (verified owner) –
Good fitment after some trimming of pipes
Benjamin Getz (verified owner) –
Can’t wat to get that far along on the project to try them.
Anonymous (verified owner) –
As described
Leif Dickinson (verified owner) –
Havent installed them yet but they look like they will work great.
Doug Hedley (verified owner) –
Arrived in prompt time. Thanks
Steve (verified owner) –
Works as advertised. I actually used the left side pipe as a starting point to build my own 2 into 1 exhaust. Having the bends on the left side needed to get past the brake lever and foot peg at the beginning really simplified the build after that. Murray was very helpful, and always responded within a day when I had questions.
Jeff nobles (verified owner) –
Perfect fit with plenty of pipe north and south for trimming.
This is the second set I’ve purchased and both fit perfectly so his bends are consistent. Next purchase will be a set of carbs.
David Soma (verified owner) –
The really look good to work with but I have yet to work on the exhaust on my project bike.
Robert T. (verified owner) –
The cuts on the pipes were not clean or or straight but they were bent perfectly…
Murray (store manager) –
the ends of the pipes are meant to be trimmed on either side
so what is the point in spending money on finishing something you need to trim off
Benjamin Liverman (verified owner) –
pipes looked great and shipping was super fast. Haven’t gotten to the point in my build yet where I’m ready to install, but you can tell that quality won’t be an issue. As always, thank you Murray for creating great products that keep these bikes [fun] on the road.
-Ben (blivy)